Sony DCR-TRV6 Service Manual page 70

2-13.HINGE ASSEMBLY, LCD HARNESS PROCESSING
Start repair work after removing LCD by performing steps 1 – 6 of 2-1 or 2-2 and remove the CK-92/94 board by
performing steps 1 – 0 of 2-5.
2 FP-181 flexible board
Be careful not to be
caught by other parts.
1 Two screws (M1.7)
with scotch grip
PRECAUTION DURING INSTALLATION (LCD HARNESS PROCESSING)
Create an extra length
to allow opening and closing.
5
3 Harness (PC-119) (14P)
Be careful not to be
caught by other parts.
4 Harness (PC-118) (12P)
Be careful not to be
caught by other parts.
Extra length is not
required in LCD.
PD-
Board
q; Hinge assembly
8 Screw
(M1.7 2.5)
9 FP-181
flexible board
5 Hinge cover (front)
Be careful thet harness must not
protrude from upper and lower side.
2-12
3 Two claws
4 Hinge cover (rear)
2 Screw (M1.7
lock ace, p2
6 Harness
(PC-118) (12P)
7 Harness
(PC-119) (14P)
1 Two screw (M1.7 4),
lock ace, p2
CK-
Board
Allow extra length of
this extent in the cabinet.
4),