Operator Calls & Service Calls; Operator Calls - Brother HL-2030 Service Manual

CHAPTER 7 TROUBLESHOOTING
2. OPERATOR CALLS & SERVICE CALLS
2.1

Operator Calls

When an operator call occurs, the red Paper LED is ON or blinking to indicate it.
An 'operator call' which the printer indicates on the LEDs is user recoverable. Identify the
error from the table below and take the corrective action described for each indication to
correct it. The printer automatically recovers from most errors, but some of errors are
necessary to reset the printer by holding down the Go button.
LED
3
clearance by
Type of error
pressing the
Go button.
Toner life end
Cartridge
position error
Drum life end
soon
No paper fed
tray
Front cover is
open
Back cover is
open
Paper jam
No paper fed
manual feed slot
Memory full
Print overrun
Dust on drum
7-4
Error
Replace the toner cartridge with a
X
new one.
The toner cartridge is not installed
correctry. Take out the toner
X
cartridge and put it back into the
printer again.
The drum unit is near the end of its
life. We recommend that you get a
new drum unit to replace the current
one. The Drum LED alternates
X
turning on for 2 seconds and off for 3
seconds.
Put paper in the tray. Press the Go
button.
Close the front cover of the printer.
X
Close the back cover of the printer.
X
Clear the paper jam. If the printer
does not start printing, press the Go
button.
Put the paper in the manual feed slot.
An error is cleared when deleting the
X
data by the job cancel operation.
An error is cleared when deleting the
X
data by the job cancel operation.
X The corona wire needs to be cleaned.
Remedy
Confidential