2.2
Service Calls
If service calls occur, all four LEDs blink on and off to notice it. In this state execute the
operation described on the top of Table 1 to notify a fault location from the specific
combination of ON/OFF and status color of the LED.
Instruct the user to turn off the power switch, wait a few seconds and then turn it on again and
try to print again. If the error is not cleared and the same service call appears, see
'MALFUNCTIONS'
<To show the service call type>
If Go button is pressed, LED is lighted by one of the combinations in the table below.
LED
<Recovering from the service call>
The printer starts recovering from all service calls by the front cover being opened and closed.
For an unrecoverable error, however, the printer detects a service call again and indicates it.
to take the corrective action.
Error occurs.
Comfirm the LED indication.
Front cover
open/close.
No error released
Turn OFF/ON the power switch.
Error occurs
again.
YES
See section 6 'MALFUNCTION'.
Type of service call
Fixing unit failure
Laser unit failure
High voltage error
Error released
OK
NO
Temporary error.
Use the printer with out
corrective action.
LED
7-5
HL-2030/2040/2070N SERVICE MANUAL
Section 6
Type of service call
Main PCB failure
Main motor failure
<Table 1>
Confidential