Printing On Thick Paper, Card Stock, Labels, And Envelopes From The Manual Feed Slot - Brother HL-2030 Service Manual

(6) After the printed page comes out of the printer, put in the next sheet of paper as in Step
(4) above. Repeat for each page that you want to print.
!
CAUTION:
If you print on transparency, remove each transparency immediately after printing. Stacking
the printed transparency may cause a paper jam or the transparency to curl.
4.3 Printing on Thick Paper, Card Stock, Labels, and Envelopes from the Manual
Feed Slot
NOTE:
The printer automatically turns on the Manual Feed mode when you put paper in the manual
feed slot.
(1) Select the Paper Size, Media Type and Paper Source and other settings in the printer
driver.
NOTE:
For envelope users
• When you use Envelope #10, select Com-10 from Paper Size in the printer driver.
• For other envelops which are not in the selection of the printer driver, such as Envelope #9
or Envelope C6, use User Defined... Size.
(2) Send the print data to the printer.
NOTE:
A MANUAL FEED status is shown by the control panel LEDs until you put a sheet of paper or
envelope in the manual feed slot.
(3) Lift up the support flap to prevent paper from sliding off the facedown output tray.
NOTE:
If you choose not to lift up the output tray support flap, we recommend that you remove
printed pages as soon as they come out of the printer.
Fig. 2-14
Fig. 2-15
2-15
HL-2030/2040/2070N SERVICE MANUAL
Confidential