Instructions for Disassembly and Assembly
5.3.2
Replacing Main
Board
B
5.3.3
Dismount Main
Electronic
–
Disconnect Mains Voltage.
–
Run steps 5.3.1 and 5.3.2.
–
Remove Top Case (see section 5.1.1).
–
Turn the lock "A" on the back of the printer indicated by the arrow.
–
Pull slightly the board half out of the Bottom Case.
–
Disconnect Mains Voltage connector "B".
–
Remove board.
Caution (T2170/T2280 only):
After replacing the main board make sure to calibrate the temperature of the
printhead (see chapter 6 "Adjustments").
Caution:
Adjust also the AGA (see chapter 6 "Adjustments").
–
Run step 5.3.2.
–
Open the according screws "A".
Replacing Electronic Parts
A
5-9