Adjustments
6
6.1
Mechanical
Adjustments
6.1.1
Tension of the
Toothed Belt
Adjustments
Depending on the actual state of the printer, you have to carry out the following
adjustments:
Mechanical Adjustments
Gap Printhead/Platen
Parallelism between Printhead and Platen
Tension of the Horizontal Drive Toothed Belt
➜ must be carried out if replacing Carriage System or Toothed Belt
Setting the physical Top of Form
Electrical Adjustments
Interface Jumper Settings
➜ Changes are only necessary if standard configuration does not work properly
Soft Adjustments
Calibrating of Head Temperature (T2170/T2280 only)
➜ must be done after installing a new printhead
➜ must be done after installing a new Main Board
Calibrating of AGA Sensor
➜ must be done after replacing of the Carriage System or printout is not satisfactory
➜ must be done after replacing of the Main Board or printout is not satisfactory
➜ must be done after replacing of the AGA system
The tension of the toothed belt can be adjusted by means of the eccentric tension
pulley located at the left side wall.
First you must remove the top casing as described in chapter 5.1.1.
Necessary tool: Scale
Mechanical Adjustments
6-1