Rewriting The Ee-Prom - Star Micronics LC-1011C Technical Manual

6-4. Rewriting the EE-PROM

Follow this procedure to rewrite the EE-PROM.
(1) Turn the printer on.
(2) Load a BASIC disk in the computer.
(3) Turn the computer on.
(4) Set a sheet of paper in the printer, and press the ON LINE switch.
(5) Enter the program listed below and run the program.
10 LPRINT CHR$(27);CHR$(26);CHR$(&H09)
20 LPRINT CHR$(27);"MW";CHR$(1);CHR$(&H01);CHR$(&HFB)
30 LPRINT CHR$(27);"MR"
BASIC Program Code
10 LPRINT CHR$(27);CHR$(26);CHR$(&H09) Enters the EE-PROM mode.
20 LPRINT CHR$(27);"MW";CHR$(1)
CHR$(&H01);
CHR$(&HFB)
30 LPRINT CHR$(27);"MR"
(6) To complete the setting, turn the printer off.
GENERAL SPECIFICATIONS
What It Does
Starts rewriting the EE-PROM.
Address data from &H01 will show
EDS mode from the EE-PROM memory
map.
Data from &HFB will change the Line-
Spacing from 1/6" to 1/8".
Dumps all EE-PROM data to hexadeci-
mal.
– 15 –