Rewriting The Ee-Prom - Star Micronics LC-4511 Technical Manual

Address
3EH, 3FH IBM Initial Condition Area
40H~5EH Auto Start Area for Standard/EPSON Mode
5FH~7CH Auto Start Area for IBM Mode
7DH <FF> Control Code (00H = Space / 0FH = Null)
7EH Colour Information
7FH EE-PROM Check Code

6-4. Rewriting the EE-PROM

Follow this procedure to rewrite the EE-PROM.
(1) Turn the printer on.
(2) Turn the computer on.
(3) Load a BASIC disk in the computer.
Set a sheet of paper in the printer, and press the SET switch.
(4)
(5) Enter the program listed below and run the program.
10 LPRINT CHR$(27);CHR$(26);CHR$(&H09)
20 LPRINT CHR$(27);"MW1";CHR$(&H01);CHR$(&HFB)
30 LPRINT CHR$(27);"MR"
BASIC Program Code
10 LPRINT CHR$(27);CHR$(26);CHR$(&H09) Enters the EE-PROM mode.
20 LPRINT CHR$(27);"MW1";
CHR$(&H01);
CHR$(&HFB)
30 LPRINT CHR$(27);"MR"
(6) To complete the setting, turn the printer off.
Function
Starts rewriting the EE-PROM.
Address data from &H01 will show
EDS mode from the EE-PROM memory
map.
Data from &HFB will change the Line
spacing from 1/6" to 1/8".
Dumps all EE-PROM data to hexadeci-
mal.
– 17 –
GENERAL SPECIFICATIONS
What It Does
Factory data
FFH
FFH
00H
00H
00H
00H
00H
00H
01H