Adjustment Of Timing Belt Tension - Star Micronics LC-1011C Technical Manual

ADJUSTMENTS
2.

Adjustment of Timing Belt Tension

The timing belt tension should be set at from 14g to 19g.
(The belt tension must be measured with the designated tension gauge [1].)
After the belt has been used for a long time, however, it may be difficult to maintain prescribed tension because of belt
deterioration or wear. In these cases, make adjustments by following the procedures listed below.
(1) Remove the upper case unit according to the procedures described in Chapter 4.
(2) Move the carriage unit [2] right and left two or three times in order to familiarize yourself with the timing belt
[3].
(3) Set the index lever [4] at step 2 as shown in Fig. 3-2.
(4) Move the carriage unit [2] to the right end.
(5) Set the arm [5] of the tension gauge [1] 127 mm apart from the frame L.
(6) Move the tension gauge [1] in the direction of the platen [6] until it stops. Then place the arm [5] of the tension gauge
on the timing belt [3].
(7) Loosen the screw [7].
(8) Insert a flat-blade screwdriver into the square hole of the tension arm [8] and adjust the belt tension by moving the
tension arm [8] left or right.
(9) When the belt has been adjusted to the prescribed tension, tighten the setting screw [7].
(10) If the belt cannot be adjusted to the prescribed tension, replace it with a new timing belt [3].
Fig. 3-5 Adjustment of Timing Belt Tension
Fig. 3-6 Tension Measurement
– 28 –