Rewriting The Ee-Prom - Star Micronics NX-1020 Technical Manual

6-4. Rewriting the EE-PROM

An example of the procedure for rewriting an EE-PROM is described below.
1. Load a Basic Disk in the personal computer, and turn on the power to the computer.
2. Hold down bothe the
power to the printer. Release the switches when you hear a beep.
3. Load a sheet of paper, and press the
4. Input the program listed below into the personal computer and run the program.
10 LPRINT CHR$(27);"MW1";CHR$(&H00);CHR$(&H80)
20 LPRINT CHR$(27);"MR"
Description of the Sample Program
This program is used to change the emulation mode from STANDARD (the factory setting) to IBM.
Line 10: CHR$ (27);"MW1" .............. This is the control code used for rewriting the EE-PROM.
&H00 .................................... Address data from &H00 will show the EDS mode from the EE-PROM
&H80 .................................... Data from &H80 will change the emulation mode from STANDARD to
Line 20: CHR$(27);"MR" .................. This is the control code used for dumping all of the EE-PROM data to
5. Turn off the power to the printer. This will complete the setting.
and
ON LINE PAPER FEED
SET/EJECT
PARK
memory map
IBM.
hexadecimal
GENERAL SPECIFICATIONS
switches on the front panel of the printer and turn on the
switch.
– 15 –