Tandberg Data StorageLibrary T40+ Series Installation And User Manual page 91

RAS Severity
Ticket Level
R3002 Urgent
R3003 Urgent
R3004 Urgent
R3005 Urgent
R3006 Urgent
R6005 High
R6006 High
R6007 High
R6008 High
R6009 High
StorageLibrary T40+ Series Installation and User Guide
Display Message Description
The Pass-Thru box The Pass-Thru
is not in place box is not in
place.
The Pass-Thru box A cartridge has
is not empty been detected in
the Pass-Thru
box.
Network connection The master
failed library is not able
to connect to the
add-on library.
Pass-Thru The master
configuration failed library is not able
to configure to
the add-on
library.
Pass-Thru is The Pass-Thru
disabled in the add- functionality is
on library disabled in the
add-on library.
Drive n Tape Alert The tape is
5. Read Failure. damaged or the
drive is faulty.
Drive n Tape Alert The tape is from
6. Write Failure. a faulty batch or
the tape drive is
faulty.
Drive n Tape Alert The tape
7. Media Life. cartridge has
reached the end
of its calculated
useful life.
Drive n Tape Alert The tape
8. Not Data Grade. cartridge is not
data-grade. Any
data you back up
to the tape is at
risk.
Drive n Tape Alert You are trying to
9. Write Protect. write to a write-
protected
cartridge.
Suggested Action
Eject the Pass-Thru magazine
and insert the Pass-Thru box. Re-
insert the Pass-Thru magazine
and retry the operation.
Eject the Pass-Thru magazine
and remove the cartridge from the
Pass-Thru box. Re-insert the
pass-thru magazine and retry the
operation.
Verify the TCP/IP addresses in
the pass-thru configuration, and
that the network connection
between the master and the add-
on library is working.
Verify that all libraries in the pass-
thru system are using the same
firmware revision.
Also verify that the TCP/IP
communication between the
master and the add-on library is
working.
Reboot and retry the operation
Please run the Setup Wizard on
the add-on library and set the
Pass-Thru configuration to "Add-
on".
Clean the drive.
Try another cartridge.
If the problem persists, replace
the tape drive.
Clean the drive.
Use a good tape to test the drive.
If the problem persists, replace
the tape drive.
Copy any data you need to
another tape
Discard the old tape.
Replace the cartridge with a data-
grade tape.
Remove the write-protection or
use another tape.
91