Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed between the
transmission of each character of scanned data. Scan the Intercharacter
Delay barcode below, then scan the number of milliseconds and the SAVE bar-
code using the
Programming Chart
To remove this delay, scan the Intercharacter Delay barcode, then set the num-
ber of steps to 0. Scan the SAVE barcode using the
the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed after the trans-
mission of a particular character of scanned data. Scan the Delay Length bar-
code below, then scan the number of milliseconds and the SAVE barcode using
the
Programming Chart
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value
for the ASCII character that will trigger the delay
Page 1252)
on page A-2.
Delay Length
To remove this delay, scan the Delay Length barcode, and set the number of
steps to 0. Scan the SAVE barcode using the
back cover of this manual.
inside the back cover of this manual.
Prefix
Scanned Data
1
2
3
Intercharacter Delay
Intercharacter Delay
inside the back cover of this manual.
Suffix
4
5
Programming Chart
ASCII Conversion Chart (Code
Character to Trigger Delay
Programming Chart
inside
inside the
4 - 5