Good Read Delay; User-Specified Good Read Delay; Image Scanner Trigger Modes; Manual/Serial Trigger, Low Power - Honeywell 2020 User Manual

Good Read Delay

This sets the minimum amount of time before the image scanner can read
another barcode. Default = 0 ms (No Delay. )
* No Delay
Short Delay (500 ms)
Medium Delay (1000 ms)
Long Delay (1500 ms)

User-Specified Good Read Delay

If you want to set your own length for the good read delay, scan the barcode
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from
the inside back cover, then scanning Save .
User-Specified Good Read Delay

Image Scanner Trigger Modes

Manual/Serial Trigger, Low Power

You can activate the image scanner either by pressing the trigger, or using a
serial trigger command (see "Trigger Commands" on page 10-4). When in
manual trigger mode, the image scanner scans until a barcode is read, or until
the trigger is released.
When in serial mode, the image scanner scans until a barcode has been read or
until the deactivate command is sent. In serial mode, the image scanner can
also be set to turn itself off after a specified time has elapsed (see Read Time-
Out (Serial Trigger Mode), which follows).
* Manual/Serial Trigger
3 - 3