Honeywell 2020 User Manual page 11

Connecting the Base with RS-232 Serial Port ............ 2-8
RS-232 Baud Rate ................................................ 2-9
RS-232 Word Length: Data Bits, Stop Bits,
and Parity ............................................................ 2-10
RS-232 Handshaking .......................................... 2-10
Host ACK Selection............................................. 2-11
Host ACK Enable ................................................ 2-12
Wand Emulation ........................................................ 2-14
Wand Emulation Connection............................... 2-14
Wand Emulation Transmission Rate ................... 2-15
Wand Emulation Polarity ..................................... 2-15
Wand Emulation Idle ........................................... 2-15
Wand Emulation Data Block Size........................ 2-16
Wand Emulation Delay Between Blocks ............. 2-16
Wand Emulation Overall Checksum.................... 2-16
Chapter 3 - Output
Good Read Indicators ................................................. 3-1
Beeper - Good Read ............................................ 3-1
Beeper Volume - Good Read ............................... 3-1
Beeper Pitch - Good Read ................................... 3-2
Beeper Duration - Good Read.............................. 3-2
LED - Good Read ................................................. 3-2
Number of Beeps - Good Read ............................ 3-2
Good Read Delay........................................................ 3-3
User-Specified Good Read Delay ......................... 3-3
Image Scanner Trigger Modes.................................... 3-3
Manual/Serial Trigger, Low Power ........................ 3-3
Automatic Trigger .................................................. 3-5
Presentation Mode ................................................ 3-5
Hands Free Time-Out ................................................. 3-6
Reread Delay .............................................................. 3-6
User-Specified Reread Delay................................ 3-6
Centering Window ...................................................... 3-7
Preferred Symbology .................................................. 3-8
iii