Tiller Assembly - Honda HARMONY FG100 Owner's Manual

ASSEMBLY

TILLER ASSEMBLY

1. Install the wheel spacers on the wheel support.
2. Install the wheels on the wheel support.
3. Retain each wheel to the wheel support with a
wheel washer and lock pin.
4. Install the wheel assembly to the bracket
assembly using the clevis pin and a lock pin.
Set the wheel height in the second hole from
the top as shown.
After the assembly is completed, select one of
the four holes that provides the most comfort
when transporting the tiller (see page 12).
5. Install the left and and right lower handles to
the transmission engine mount with the two
1/4-20 x 4 1/2 inch bolts, four curved washers
and two 1/4 inch locking nuts. Do not tighten
the mounting bolts at this time.
The left and right lower handles are identified
by the different lengths from the end of the pipe
to the mounting bolt hole as shown.
30
WHEEL WASHER
SPACER
WHEEL (2)
LOCK PIN
LOCK
WHEEL
LEFT
LOWER
1 in
(25 mm)
1/4-20 x 4 1/2
TRANSMISSIO
N ENGINE
WHEEL
WHEEL WASHER
BRACKET
CLEVIS
RIGHT
CURVED
5 1/4 in
(135 mm)
1/4 inch
FG100 TILLER