Tiller Operation - Honda FF500 Owner's Manual

Front wheel position adjustment
Front wheel height can be changed to adjust the tilling depth and to transport
the tiller.
1. Set the tiller on a firm level ground and hold it securely by placing a suitable
block under the transmission case.
2. Pull the front wheel beam forward to move the pin out of the groove and set it
in the groove you want. Then, secure the pin in the position.
NOTE:
When the ground is too soft and the tiller gets into the ground, or when the
ground is too hard, adjust the tilling depth in a shallow position.
a For transportation Rotary ground clearance:
Approx. 30 mm (1.2 in)
b Tilling depth: Approx. 20 mm (0.8 in)
c Tilling depth: Approx. 60 mm (2.4 in)
d Tilling depth: Approx. 120 mm (4.7 in)
e Tilling depth: Approx. 160 mm (6.3 in)
f Tilling depth: Approx. 200 mm (7.9 in)
GROOVE
FRONT WHEEL BEAM

6. TILLER OPERATION

PIN
25