Troubleshooting and Tips
7.10
Drives Are Reported as "Dead"
This error message may occur with an incorrect configuration of the RAID
controller.
RAID controller configuration incorrect
Ê Check and correct the settings for the drives with the RAID controller utility.
Further information is provided in the manual on the RAID controller.
7.11
Added Drive Reported Defective
This error message may occur with an incorrect configuration of the RAID
controller.
RAID controller is not configured for this hard disk drive
The drive was probably installed when the system was switched off.
Ê Reconfigure the RAID controller for the drive with the corresponding utility.
Further information is provided in the manual on the RAID controller.
or
Ê Remove and reinstall the drive while the system is switched ON (see
"Installing the HDD module" on page
If the drive continues to be shown as defective, then replace it.
7.12
Error Messages on the Screen
The meaning of the error messages is explained in the documentation for the
relevant components and programs on the PRIMERGY ServerBooks CD.
RX220
Drives Are Reported as "Dead"
66).
Operating Manual
61