Related Manuals for TRENDnet TPL-210AP
Summary of Contents for TRENDnet TPL-210AP
- Page 1 Quick Installation Guide TPL-210AP...
-
Page 2: Table Of Contents
Table of Contents Table of Contents English ... 1. Before You Start 2. Install Hardware ... 3. Configure the Access Point ... Troubleshooting ... Version 12.14.2006... -
Page 3: English
A computer with a network adapter properly installed and a Powerline Ethernet bridge such as the TPL-202E Existing HomePlug 1.0 or HomePlug 1.0 Turbo network A RJ-45 network cable. Application 85Mbps Powerline Wireless Access Point (TPL-210AP) Workstation with Wireless PCI Adapter (TEW-423PI) Internet Cable/DSL Modem... -
Page 4: Install Hardware
Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Note: DO NOT plug the TPL-210AP into a power strip or surge protector. 1. Connect the 2dBi Detachable Antenna. -
Page 5: Configure The Access Point
3. Configure the Access Point Note: It is recommended that you configure the Access Point from a computer connected to a Powerline Ethernet Bridge (e.g. TPE-202E). Before the Access Point can be configured, a Static IP address must be assigned on your computer's network adapter in the subnet of 192.168.1.x. - Page 6 4. Click Wizard. 5. Click Next. 6. Enter a new password for your Access Point, verify the new password, and then click Next. (If a new password is not entered, the default password admin will be used. 7. Enter a SSID for your Access Point and then click Next.
- Page 7 8. Enable Encryption if needed and then click Next 9. Click Restart. 10. Click Close. Your configuration is now complete. For detailed information regarding the TPL-210AP's configuration, please refer to the Troubleshooting section, User's Guide CD-ROM, or Trendnet's website at http://www.trendnet.com. English...
-
Page 8: Troubleshooting
I specified the IP address http://192.168.1.200 in my Internet Browser's Address Bar, but an error message says "The page cannot be displayed". How can I get into the TPL-210AP's web configuration page? First, check your hardware settings again by following the instructions in section 2. - Page 9 Click HomePlug. Change the HomePlug Group name to match your network's Powerline network name. The default HomePlug Group name is HomePlug. Second, verify that the power outlet the TPL-210AP is plugged into is on the same electrical power distribution and/or circuit breaker. Third, if you have a DHCP server in your network, you need to go into TCP/IP settings again and re-select "Obtain an IP address automatically"...
- Page 10 Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
- Page 11 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com 20675 Manhattan Place Torrance, CA 90501 Copyright ©2007. All Rights Reserved. TRENDnet.