To Specify A Dns Address Manually - 3Com EtherLink III ISA User Manual

To Specify a DNS Address Manually

Follow these steps to specify a DNS address manually:
1 Select the Specify DNS manually radio button if you are
using a permanent DNS address. See Figure 3-9.
Figure 3-9 Specifying a DNS Address Screen
If DNS has been previously configured on your PC, the fields on
this screen may already be filled in.
If DNS has not been previously configured on your PC, these fields
are blank and you must fill them in to enable DNS.
2 Enter the host and domain data in their respective fields.
3 To configure a new server, enter the new server address,
and then click Add New Server.
The new server appears in the Servers list box.
4 Click Test DNS Connection to verify that the connection to
the DNS server is functioning.
While the test is running, a progress bar indicates test progress.
If a test fails, a message indicates the error type. Click the Help
button in the error message screen to obtain more information.
Chapter 5 provides additional troubleshooting help.
A message confirms that the DNS connection is functioning.
5 Click Next.
The next step is to identify your PC on the network.
Configuring DNS 3-9