Performing Automated Installations; Installing From The Hard Disk; Installing From A Diskette - 3Com EtherLink III ISA User Manual

5-10 C
HAPTER

Performing Automated Installations

This section describes how to install and configure 3C509B NICs
when you want to perform multiple installations automatically or
when you must reinstall the NIC software because it has been lost
or corrupted.
This procedure uses configuration settings saved from a
previous installation.

Installing from the Hard Disk

Follow these steps if the saved configuration settings are in a file
on your hard disk:
1 Click Start in the taskbar, click Run, and then enter the path
to the file that contains the saved configuration settings
that you want to use to reinstall the NIC.
2 Click OK.
The 3Com Installation Wizard starts and displays the first screen.
3 Click Install.
3Com Installation Wizard screens appear sequentially, displaying
the settings saved in the original installation.

Installing from a Diskette

Follow these steps if the saved configuration settings are in a file
on a diskette:
1 Insert the diskette containing the saved configuration
settings in drive A.
2 Click Start in the taskbar, click Run, and then enter:
a:\
3 Click OK.
The 3Com Installation Wizard starts and displays the first screen.
4 Click Install.
3Com Installation Wizard screens appear sequentially, displaying
the settings saved in the original installation.
5: W 95
INDOWS AND
W NT T
INDOWS ROUBLESHOOTING