Care Of The Spa Cover; Retractable Cover Systems - HotSpring Landmark Owner's Manual

Damage to the shell by the use of harsh chemicals is not covered under the warranty.
IMPORTANT: Some surface cleaners contain eye and skin irritants. Keep all cleaners out of the reach of children and use care
when applying.
®
EVERWOOD SPA CABINET
®
Hot Spring Spas include an Everwood
with the beauty of redwood. Everwood
®
Cleaning of Everwood consists of simply spraying the cabinet with a mild soap and water solution to remove any stains and
residue.
®
Do not rub the Everwood with an abrasive material or use abrasive cleaners as this may damage its texture.
Watkins Manufacturing Corp. recommends touch-up or restaining of the Everwood
according to the environment). Contact your local dealer for restaining procedures and recommended stains.

CARE OF THE SPA COVER

WARNING: The cover is a manual safety cover that meets or exceeds all prevailing requirements of ASTM Standards for spa safety
covers when installed and used correctly as of the date of manufacture. Non-secured or improperly secured covers are a hazard.
Open the cover to its fully open position before use.
VINYL COVER
The vinyl spa cover is an attractive, durable foam insulation product. Monthly cleaning and conditioning are recommended to
maintain its beauty.
To clean and condition the vinyl cover:
1. Remove the cover from the spa and gently lean it against a wall or fence.
2. With a garden hose, spray the cover to loosen and rinse away dirt or debris.
3. Using a large sponge and/or a soft bristle brush, and using a very mild soap solution (1 teaspoon dishwashing liquid with 2
gallons of water) or baking soda (sodium bicarbonate), scrub the vinyl top in a circular motion. Do not let the vinyl dry with a
soap film on it before it can be rinsed clean.
4. Scrub the cover's perimeter and side flaps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (use no soap), and wipe it clean with a dry rag.
6. To condition the cover after cleaning, apply a thin film of Hot Spring
luster.
SERVICE NOTE: To remove tree sap, use cigarette lighter fluid (not charcoal lighter fluid). Use sparingly, and rinse with a
saddle soap solution immediately afterwards, then wipe dry.
Important reminders:
• DO remove snow buildup to avoid breakage of the foam core from the additional weight of the snow.
• DO lock cover lock straps to secure the cover when the spa is not in use.
• DO NOT drag or lift the spa cover using either the flaps or the cover lock straps.
• DO NOT walk, stand, or sit on the cover.
• DO NOT place any metal or heat transferring object on the cover or place any type of plastic tarp or drop cloth over the
cover as this may result in a melted foam core, which would not be covered under the warranty.
• DO NOT use any lifting mechanisms, chemicals or cleaners except those recommended by Watkins Manufacturing
Corporation or its Authorized Sales and Service Dealer.
HOW TO OPEN THE VINYL COVER WITH A HOT SPRING
RETRACTABLE COVER SYSTEM
NOTE: Never attempt to open or remove the vinyl cover by grasping or pulling on the skirting or cover lock straps. The skirting will
tear, and torn skirting is not covered under the terms of the warranty.
Check for ice build-up around the gas shocks and pivot points of the retractable cover system. Ice buildup may damage system
components.
WARNING: The vinyl cover and retractable cover system are not recommended for use in wind conditions reaching above 25 mph
(40 kmh).
NOTE: If your spa is located in an area susceptible to high winds, additional coverlock straps may be installed to minimize wind
damage to the cover.
® ®
spa cabinet. Everwood consists of a rigid polymer that combines the durability of plastic
®
won't crack, peel, blister or delaminate even after prolonged exposure to the elements.
Page 39
®
every three to four years (this will vary
® ™
Cover Shield to the vinyl surface and buff to a high
Spa Care and Maintenance
®