Water Care; Auxiliary Control Panel - HotSpring Landmark Owner's Manual

The CLEAN button, provided as a convenient timer for water maintenance, activates the jet pump for a ten minute period.
The CLEAN indicator will turn on and the JET symbol on the display will illuminate to indicate the jet pump is engaged.
Next you may add properly measured spa water chemicals into the filter compartment. The jet pump and clean indicator
will automatically shut off after 10 minutes.
If the jet pump will not engage, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the main
and auxiliary control panels.
LIGHT CONTROL
The intensity of the spa's light is controlled using the LIGHT plus (+) or LIGHT minus (-) buttons.
To turn on the spa light, press the LIGHT plus (+) button. The light will turn on at maximum intensity and the
light symbol will illuminate on the control panel display.
To reduce the intensity of the light, press the LIGHT minus (-) button. The intensity of the light will
decrease each time the button is pressed. Additionally, if either of the LIGHT buttons (+ or -) on
the Main Control panel only, are held down, the light intensity will increase or decrease at the rate
of one intensity level every half-second.
To turn off the light, hold the LIGHT minus (-) button. The light will dim and turn off. When the light turns off, the light
symbol on the display will also turn off.
If the light is left on, it will automatically be turned off by the control system after 6 hours of continuous operation. The light
symbol on the panel will also turn off when the light is deactivated.
If the light will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the main
and auxiliary control panels.

WATER CARE

If your spa is equipped with a FreshWater
illuminate whenever the ozone system is running and the screen is not blank. Should a
problem occur with the ozone system, the diplay will flash on and off. See FRESHWATER
OZONE SYSTEM section for more information.
SUMMER MODE DISPLAY
The Summer Mode symbol is on when the Summer Mode timer is on. When activated, the symbol
will be visible even in bright light when the main display backlight is off. In low light conditions, the
Summer Mode symbol will only be visible when the display is activated by pressing a control
panel button.

AUXILIARY CONTROL PANEL

The auxiliary control panel, conveniently located in the spa seating area (Landmark
®
and Prodigy models), allows the user to activate the jets and light from inside the spa.
NOTE: Keep in mind that the auxiliary control panel will not function if the SPA LOCK feature on the main control panel has
been activated.
JETS CONTROL
There is one button (two buttons on Landmark
which affects the jet pump(s):
The JETS button (all models) / JETS 1 (Landmark
only) activates the jet pump. When the JETS or JETS 1 button is pressed,
the jets symbol will illuminate on the main control panel display. The
symbol will remain lit until the button is pressed again to turn off the jet
pump, or after two hours of continuous operation when the pump is
automatically shut off by the control system.
®
The JETS 2 button (Landmark
pump. When the JETS 2 button is pressed, the jets symbol will illuminate on
the main control panel display. The symbol will remain lit until the button is
pressed to turn off the jet pump, or after two hours of continuous operation
when the pump is automatically shut off by the control system.
If the jet pump will not engage, make sure SPA LOCK is deactivated. SPA
LOCK disables the controls on both the main and auxiliary control panels.
®
III Ozone System, the Water Care display will
®
and Grandee
®
and Grandee
®
and Grandee only) activates the second jet
®
III
®
, Grandee
®
models)
®
models
Page 35
® ™ ®
, Vanguard , Sovereign ,
Operating Instructions
Vanguard
™
Sovereign ®
Prodigy
®
Landmark ®
Grandee
®