Freshwater Ag+ Silver Ion System; Everfresh Water Care System - HotSpring HOT SPOT Tempo Owner's Manual

FRESHWATER
The Silver ion system is comprised of the following products:
• FRESHWATERSodium Dichlor
• FRESHWATERMonopersulfate (MPS)
• FRESHWATER
silver ion purifie
Ag +
• CLEAN SCREEN Pre-Filter
CLEAN SCREEN Pre-Filter is used when filling a spa for the first time, at top off, or at refill. It attaches to a garden hose and filters out rust, dirt,
detergents, algae and chemicals.
FRESHWATER Sodium Dichlor (chlo rine) is the only recommended sanitizer that will work in conjunction with all of the other products in this
system..
FRESHWATERMonopersulfate (MPS) is an oxidizing chemical used to prevent the buildup of contaminants, maximize sanitizer efficiency, minimize
combined chlorine, and improve water clarity.
FRESHWATER silver ion purifier introduces silver ions into the spa water, inhibiting bacteria growth. When combined with MPS, or chlorine,
Ag +
oxidizes particulates in the spa water.
It is important to follow the recommended application and maintenance programs outlined for each product's use.
If the spa is being used over an extended period of time, such as a whole afternoon or evening, additional sanitizer will be needed.
A weekly "shock treatment" is required.
The shock treatment quickly destroys any remaining contaminants while revitalizing the silver ion cartridge, allowing the silver ions to continue to be
released into the water. Without this weekly shock treatment, the silver ion cartridge may stop releasing silver ions into the water.
To weekly "shock treat" your spa you may use either MPS or sodium dichlor. It will require much less sodium dichlor to administer the shock
treatment than MPS (one teaspoon of sodium dichlor has oxidizing capabilities comparable to two tablespoons of MPS). Sodium dichlor may be
a more appropriate weekly shock for those users that experience heavy bather load conditions.
IMPORTANT NOTE: MPS is an oxidizer, not a sanitizer.

EVERFRESH WATER CARE SYSTEM

The EVERFRESH water care system is comprised of the FRESHWATER Ag+ Silver ion and the FRESHWATER III high output ozone system
FRESHWATER Ag+ silver ion System (see above).
FreshWater III high output ozone system (Optional) uses Corona Discharge technology to produce a high concentration of ozone, which is
injected into the spa water
FRESHWATER
Ag+
When replacing the FRESHWATER
same time. After refilling the spa with water, balance the Total Alkalinity (TA), Calcium Hardness (CH) and pH to the recommended levels. Shock
the spa by adding sodium dichlor (See Sanitization Table for details).
1. Fold back the vinyl cover.
2. Remove any floating items within the filter compartment.
3. Locate the filter retainer handle. Turn the filter retain handle counterclockwise until the cap can be removed from the filter standpipe.
4. Remove and clean filter cartridges.
NOTE: When replacing the FRESHWATER
FRESHWATER
silver ion purifier.
Ag +
5. Install the new FRESHWATER
6. Reinstall the cleaned filter cartridges.
7. Replace and secure the filter retainer handle or filter basket and cap.
8. Fold the cover back into place.
WARNING: Never use the spa with the filter cartridges or filter standpipes removed!
SILVER ION SYSTEM
AG+
SILVER ION PURIFIER REPLACEMENT INSTRUCTIONS
silver ion purifier (every four months) it is highly recommended that the spa be drained and refilled at the
Ag +
silver ion purifier, it is an excellent time to clean the filter to extend the life. Remove the existing
Ag +
silver ion purifier into the filter standpipe as illustrated in the Silver Ion instructions.
Ag +
Page 36 Water Quality and Maintenance