Intermec PF2 4i User Manual page 6

the Software under the following conditions and limitations:
a. You may install and use the Software solely on Systems. You
may make copies of the Software only for installation and use on
Systems which You own or operate. You shall not copy, distribute,
sell, resell, loan, sublicense, install or use the Software for any other
purpose.
b. You shall not remove, deface or delete any of the intellectual
property rights notices including copyright or trademark legends
and other notices appearing on the original Software copy or
Documentation.
c. Your license to hold and use the Software pursuant to this
Agreement is restricted solely to You and shall not be assigned,
transferred, sublicensed, encumbered, or subjected to any security
interest without the advance written authorization of Intermec.
Any attempt to transfer, assign, sublicense or encumber the
Software shall be void and of no effect.
d. The Software is protected under the copyright laws of the
United States and international copyright treaties, as well as
other intellectual property laws and treaties. You agree that if
any unauthorized copies are made, or if the Software is used
in violation of this License, Intermec shall have the right to
obtain an injunction against the unauthorized copying or use, in
addition to any other rights and remedies Intermec might have.
You acknowledge and agree that nothing in this Agreement gives
you any right, title or interest in the Software except the limited
license rights expressly granted herein. Some or all of the Software
may have been developed by an independent third party software
supplier which holds copyright or other proprietary rights to the
Software. You may be held responsible to any such supplier for any
infringement of such rights.
e. You agree that You will not export or import any portion of the
Software to any country that is not party to either: (i) The Berne
Convention of 1989, (ii) The Universal Copyright Convention,
(iii) The Buenos Aires Convention, or (iv) a treaty with the United
States of America (U.S.A.) which allows for the recognition of the
property rights claimed by Intermec or its suppliers in the Software.
Any export or import of the Software to such country in violation
of this section is prohibited and shall constitute a breach of this
License.
vi ZSim v5.XX User's Guide