Simulation Resolution; Units; Use Last Saved; X-Offset - Intermec PF2 4i User Manual

Simulation Resolution

Purpose:
Default:

Units

Purpose:

Use Last Saved

Purpose:

X-Offset

Purpose:
Default:

Y-Offset

Purpose:
Default:

^CI command again.
Set the resolution of the Zebra printer being
simulated. You can set this command to 152 dpi, 203
dpi, or 300 dpi.
Note: The resolution between the simulated printer
and your printer may cause a difference in bar code
quality. See the Optimize Bar Code Magnification
command for more information on fine-tuning the
resolution.
203 dpi if printer is fitted with a 203 dpi printhead
300 dpi if printer is fitted with a 300 dpi printhead
The unit of measurement used when entering the
Label Length or Label Width values. You can set
this command to [mm] or [inch]. This parameter
is automatically set during the Initial Setup
Configuration process.
Sets all of the ZSim program values back to the last
saved configuration.
Positions the printout distance from the left edge of
the label in [dots]. Range ± 0 to 999 dots.
0 dots
Positions the printout distance from the front edge of
the label in [dots]. Range ± 0 to 999 dots.
0 dots
ZSim v5.XX User's Guide