What Is Zsim; System Requirements; Zsim V5.Xx Vs. V4.Xx; Loading Zsim To Your Printer - Intermec PF2 4i User Manual

What is ZSim?

ZSim is a Zebra™ interpreter program that allows you to use your legacy
Zebra programs on an Intermec EasyCoder PF2i, PF4i, PF4i Compact
Industrial, PM4i, PX4i, PX6i or PD41 printer with Fingerprint. All you
need to do is download the ZSim program onto your printer, configure
a few settings, and start sending Zebra commands. The ZSim program
comes either factory installed (not on PD41), stored on a CompactFlash
card, or as a Field Installer file for user installation (not described in this
manual).

System Requirements

ZSim v.5.XX requires Fingerprint firmware version 8.60 or later, with the
exception of the PD41 which requires at least version 10.0.0.
The printer must be equipped with a minimum of 8 MB of DRAM.

ZSim v5.XX vs. v4.XX

Version 5 of ZSim provides significantly improved throughput for batch
printouts. Support for upgrade of firmware, configuration and setup
using Wavelink Avalanche has been added (not described in this manual).

Loading ZSim to Your Printer

1 Turn off your printer.
2 Insert the ZSim CompactFlash card in the card slot on the back of
your printer. The card should slide easily into place. See illustration on
next page.
3 Turn on your printer.
The download process starts automatically. Your printer screen will
display a series of messages .
ZSim v5.XX User's Guide