Installing Harness System - Safety 1st Complete air 65 Instruction Manual

4358-5295 Complete Air 7/15/10
C-9 Installing Harness System
1.
2.
3.
1
2
26
8:38 AM Page 29
Install Buckle
Fit the buckle's metal retainer
through the slot in the child
restraint. Red button must
face out.
Pull buckle's metal retainer
completely through pad
and plastic shell from
bottom of child restraint.
Check Buckle
Pull up on buckle to make
sure it is secured. The
buckle must not pull out.
Thread Harness Strap
Thread the harness down
through slot on left side of
plastic shell (1) and up
through slot on right side (2).
NOTE: Make sure sewn end
of the harness strap loop
faces the buckle before
starting.
Take both ends of the
harness and make them
even in length.
NOTE: Make sure harness
tightening strap is between
the harness strap and
plastic shell as shown.
4.
Thread harness straps
through each buckle
tongue (3). Thread the
chest clip (4). Do the same
4
to the other harness end.
Do Not twist harness.
3
5.
Thread harness strap into
the harness cover. Do Not
twist harness straps.
6.
Push harness ends through
slot in headrest. Repeat
for the other harness
strap.
7.
Thread Harness Straps
OVER Metal Bar
27 continued on next page.
Meijer.com