Using Auto Setup (Intellibeam) - Yamaha YSP-4300 Owner's Manual

Initial settings
ENTER
SYSTEM
MEMORY
24
En

Using AUTO SETUP (IntelliBeam)

Notes
• It is normal for loud test tones to be output during the AUTO
SETUP procedure. Make sure that there are no children around
in the listening room while the AUTO SETUP procedure is in
progress.
• If there are curtains in your listening room, we recommend
following the procedure below.
1 Open the curtains to improve sound reflection.
2 Run "BEAM OPTIMIZE ONLY" (☞p. 26).
3 Close the curtains.
4 Run "SOUND OPTIMIZE ONLY" (☞p. 26).
• Make sure that your listening room is as quiet as possible. For
accurate measurement, turn off air conditioner or other devices
that make noises.
1
RETURN
Turn the unit and your TV on.
2
Switch TV input to display video input
from this unit (☞p. 21).
3
Connect the IntelliBeam microphone to the
INTELLIBEAM MIC jack on the rear of the
unit.
IntelliBeam microphone