Table of Contents
Advertisement
Communication (Mic & Speaker Mode)
y
For more information about Skype, visit the following website.
Skype website: http://www.skype.com/
Setup
To use this unit with Skype, you need to carry out the
following setup procedure. For further information, refer
to "Quick Start Guide" supplied with this unit.
1
Connect the PC to the Internet.
2
Connect this unit to the PC using the
supplied USB cable.
3
Install Skype.
4
Install the PJP-25URS Controller and then
run the PJP-25URS Controller.
5
On Skype, permit access from the PJP-
25URS Controller.
appears in the task tray (the lower right screen).
The setup is complete.
Notes
• When
appears in the task tray, you cannot access Skype
from the PJP-25URS Controller. To use this unit with Skype,
permit access from the PJP-25URS Controller on Skype.
• In case this unit's microphones do not pick up any sounds or if
you cannot hear any sounds from this unit's speakers, this unit
may not be selected as an audio device in the "Audio settings"
screen on Skype. Refer to "Checking the Connection" (page
18)".
Making a call
1
On Skype, specify a phone number or click
on a contact to call.
2
Press
(off-hook).
3
Start a conversation.
Adjust the speaker volume if necessary.
4
Press
(on-hook).
The call ends.
Accepting an incoming call
1
While receiving an incoming call, press
(off-hook).
2
Start a conversation.
Adjust the speaker volume if necessary.
3
Press
(on-hook).
The call ends.
Rejecting an incoming call
1
While receiving an incoming call, press
(on-hook).
The incoming call ends.
11
Advertisement
Table of Contents
