Yamaha YSP-4300 Owner's Manual page 31

Setting the HDMI control function
1
Turn on all components connected to this
unit via HDMI cable.
2
Enable the HDMI control function of all
components connected to this unit via
HDMI cable.
For this unit, set "HDMI CONTROL" to "ON" (☞p. 63).
For external components, refer to the manual supplied
3)
with each component.
3
Turn off the TV and then turn on it again.
Registering HDMI compatible
components to the TV
1
Select this unit as the input source of the
TV.
2
Turn on an external components, such as
a Blu-ray disc player, connected to this
unit via HDMI cable.
3
Select the input source of this unit to
Blu-ray disc player and check whether the
image in the player is correctly displayed
or not.
If the Blu-ray disc player is connected via HDMI IN1
jack, press the HDMI1 key.
Input source name
HDMI1
4
Check if the HDMI control function works
(turn on this unit or adjust the volume level
using the remote control of the TV).
y
2)
• The default setting is "OFF".
• When "HDMI CONTROL" is set to "ON"
When the Eco function (☞p. 41) is enabled, this unit enters standby
mode if the TV is selected for audio output using the TV's remote
control.
y
3)
The example of TV settings
• From the setup menu on your TV, select "Link setting"
control setting", then set a setting such as "HDMI control function" to
"ON".
• Setting such as "Speaker priority" should be set to "AV amplifier".
2)
4)
"HDMI
If the HDMI control function is not working
Be sure that all components are correctly connected to this
unit, and that settings are properly configured as described
below.
– The TV is connected to the HDMI OUT (ARC) jack of this
unit.
– "HDMI CONTROL" (☞p. 63) is set to "ON" in the setup
menu.
– The HDMI control function is enabled on the TV. (Also
check the relative settings such as power interlock function
or speaker priority.)
When the HDMI control function is not still working even
after the above has been checked,
– Turn off this unit and the TV, and then turn them back on
again.
– Disconnect the AC power supply cable of the unit and
external components connected to the unit via HDMI cable.
Plug them in again after about 30 seconds.
– After OPTICAL, ANALOG, AUX, YIT, or USB
has been enabled, switch the input source for the TV and
this unit to the components connected via HDMI cable.
Changing the connection method and
connected components
When the connected components and jacks are changed, reset this
unit with the following procedure.
1
Disable the HDMI control function of the
TV and Blu-ray disc player, turn off all
connected components, and change the
connections.
2
Perform steps 1 to 3 of "Setting the HDMI
control function".
y
4)
For some HDMI compatible components, registering HDMI compatible
components to TV is not required in this case when the HDMI control
function is enabled.
y
5)
YSP-4300 only
Initial settings
5)
input
31
En