Honda Outdoor Motor BF75D Owner's Manual page 129

PGM-FI System
The PGM-FI system uses sequential
multiport fuel injection. It has two
subsystems: Engine Control, and
Fuel Control. The Engine Control
Module (ECM) uses various sensors
to determine how much air is going
into the engine. It then controls how
much fuel to inject under all
operating conditions.
TECHNICAL AND CONSUMER INFORMATION
The U.S. and Calif ornia Clean
Air Acts
EPA and California regulations
require all manufacturers to furnish
written instructions describing the
operation and maintenance of
emission control systems.
The following instructions and
procedures must be followed in order
to keep the emissions from your
Honda engine within the emission
standards.
Tampering and Altering
Tampering with or altering the
emission control system may increase
emissions beyond the legal limit.
Among those acts that constitute
tampering are:
Removal or alteration of any part
of the intake, fuel, or exhaust
systems.
Alterations that would cause the
engine to operate outside its design
parameters.
127