Honda Outdoor Motor BF75D Owner's Manual page 100

SERVICING YOUR OUTBOARD MOTOR
BAFFLE
PLATE
O-RING
BODY
SCREW (3)
WATER
SEPARATOR
CUP
7. Remove the three screws and
separate the water separator cup
from the body.
8. Thoroughly clean the water
separator cup.
9. Reassemble the water separator
body, baffle plate, O-ring and the
cup.
TIGHTENING TORQUE:
2.5 lbf·ft (3.4 N·m , 0.35 kgf·m)
98
Assemble so the flat part on the
back of the suspension is parallel
to the water separator joint as
shown below.
Assemble so the flat part of the
suspension and the water separator joint
are parallel to each other.
SUSPENSION
STRAP
WATER
SEPARATOR
FLAT PART ON BACK
OF SUSPENSION
POSITIONING
BAND
HARNESS
CLIP
CLIP C
10. Connect the water level sensor 2P
JOINT
connector. Install the harness to
clip C and the harness clip.
Align the positioning bands on the
harness with the end of clip C and
the harness clip as shown above.
11. Reinstall the water separator in the
reverse order of removal.
WATER LEVEL
SENSOR 2P
CONNECTOR
POSITIONING
BAND