Honda Outdoor Motor BF75D Owner's Manual page 120

TAKING CARE OF UNEXPECTED PROBLEMS
FUSE PULLER
5. Use the fuse puller from the tool
kit to remove the fuses. If a fuse is
blown, install a replacement fuse
of the same specified rating. The
outboard motor is supplied with
spare fuses in the fuse holder.
MAIN FUSE RATINGS:
10A, 15A, 30A
6. Reinstall the fuse case lid,
electrical parts cover, and the
engine cover.
118
7. Reconnect the battery.
Never use a f use with a rating
greater than specif ied. Serious
damage to the electrical system could
result.
If a blown fuse is found, try to
determine and correct the electrical
problem that caused the blown fuse.
An uncorrected electrical problem
may cause the fuse to blow again.
If fuses continue to blow, take the
outboard motor to an authorized
Honda Marine dealer for inspection
and service, or refer to the shop
manual.
ACG Fuse
SPARE FUSE (70A)
''70A''MARK
FUSE CASE
LID
ACG FUSE (70A)
1. Stop the engine and disconnect the
battery cable.
2. Remove the engine cover.
3. Remove the electrical parts cover.
4. Remove the fuse case lid.
5. Remove the old fuse by removing
two 5 mm screws.