Procedure
1
Gently peel off and release the antennas from the alignment posts on the
display bezel.
2
Press the securing clips and disconnect the LVDS cable from the display panel.
3
Disconnect the control-buttons board cable from the control-buttons board.
4
Disconnect the power-button cable from the control-buttons board cable.
5
Remove the screws that secure the cables to the display bracket.
8
7
1
screws (3)
3
LVDS cable
5
power-button cable
7
alignment posts (2)
NOTE: Note the routing of the cables before you remove them so that you can
route them correctly after you replace the stand assembly.
56
|
Removing the Stand Assembly
2
1
6
2
left antenna
4
securing clips
6
control-buttons board cable
8
right antenna
4
5
3