Replacing The Stand Assembly; Procedure; Postrequisites - Dell Inspiron 2350 Owner's Manual

Replacing the Stand Assembly

WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 11. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.

Procedure

1 Connect the touchscreen cable to the display panel and adhere the Mylar over the
touchscreen cable.
2 Place the stand assembly on the display assembly.
3 Slide the tabs on the stand assembly into the slots on the display bracket.
4
Align the screw holes on the stand assembly with the screw holes on the display
bracket.
5 Replace the screws that secure the stand assembly to the display bracket.
6
Route all the cables through their routing guides.
7 Replace the screws that secure the cables to the display bracket.
8 Connect the power-button cable to the control-buttons board cable.
9 Connect the control-buttons board cable to the control-buttons board.
10 Connect the LVDS cable to the display assembly.
11
Align the antenna modules with the alignment posts and adhere them to the
display bezel.

Postrequisites

1 Replace the microphones. See "Replacing the Microphones" on page 50.
2 Replace the camera. See "Replacing the Camera" on page 48.
3 Replace the back cover. See "Replacing the Back Cover" on page 44.
4 Replace the computer base. See "Replacing the Computer Base" on page 20.
5
Replace the base cover. See "Replacing the Base Cover" on page 17.
Replacing the Stand Assembly
59
|