9. CLEANING AND FLUSHING
Thoroughly clean and flush the out-
board motor with fresh water after
operation in dirty or salty water.
Flushing
with the water
hose adapter
(optional
equipment)
Do not run the engine dunng this
flushing procedure. For safety,remove
the emergency stop switch clip, so the
engine cannot be started while you
are standing near the propeller.
1. Remove the flush port cap.
WATER HOSE ADAPTER
2
(optional equipment)
2. Install the water hose adapter (optional
equipment) in the flushing connector.
3. Connect a water hose to the water hose
adapter (optional equipment), and turn
on the water supply.
85