Starting The Engine - Honda Outboard Motor BF115A Owner's Manual

5. STARTING THE ENGINE
FUEL HOSE CONNECTOR
I I
I
2. Connect the fuel hose connector
to the outboard motor. Install the
outboard end fuel hose connector
with the clip toward the inside.
Be sure the fuel hose connector is
securely snapped in place.
(NOTICE1
If
the outboard end
fuel
hose connector
is forcibly installed in the reversed
direction, thefuel hose connector O-ring
seal can be damaged. A damaged O-ring
seal can cause a fuel leak.
50
m Gasoline is highly
L -
flammable and explosive.
You can be burned or seriously
injured when handling fuel.
l
Stop engine and keep heat,
sparks and flame away.
l
Handle fuel only outdoors.
l
Wipe up spills immediately.
A&-
:
OUTLET END
/I
(MOTOR)
PRIMER BULB
3. Hold the primer bulb so that the
outlet end is higher than the inlet
end. The arrow on the primer
bulb points upward. Squeeze the
primer bulb several times until it
feels firm, indicating that fuel has
reached the engine. Check
for fuel leaks and repair any leaks
before starting the engine.
Do not squeeze the primer bulb
when the engine is running.