Honda Outboard Motor BF115A Owner's Manual page 116

11. STORAGE/WINTEFUZATION
For longer service life of the outboard
motor, have your outboard motor ser-
viced by an authorized Honda Marine
dealer before storage.
If you are unable to take the motor to
your dealer, proceed as follows:
Draining the Vapor Separator
Be careful not to spill gasoline. Spilled
gasoline or gasoline vapor may ignite.
If any gasoline is spilled, make sure
the area is dry before storing or trans-
porting the motor. Do not smoke or
allow flames or sparks where gasoline
is drained or stored.
m Gasoline is highly
flammable and explosive.
You can be burned or seriously
injured when handling fuel.
l
Stop engine and keep heat,
sparks, and flame away.
l
Handle fuel only outdoors.
VAPOR SEPARATOR
DRAIN H&E
I. Remove the drain hose from the
silencer case.
2. Connect the drain hose to the drain
joint of the vapor separator and set the
other end of the hose toward the
outside of the engine undercase.
3. Tilt up the outboard motor.
4. Loosen the vapor separator drain screw
and drain the vapor separator.
5. After draining thoroughly, tighten the
drain screw securely.
6. Install the drain hose to the silencer
case.
l
Wipe up spills immediately.
114