Honda Outboard Motor BF115A Owner's Manual page 78

6. OPERATION (MOTOR PROTECTION SYSTEM)
When the oil pressure warning systems
is activated:
1. Stop the engine immediately and
check the engine oil level (refer to
page 41).
2. If the oil is up to the recommended
level, restart the engine. If the oil
pressure indicator system stops after
30 seconds, the system is normal.
If the throttle was closed suddenly
after cruising at full throttle, the
engine speed may drop below the
specified idle speed. This could
cause the oil pressure indicator
system to activate momentarily.
3. If the oil pressure indicator system
stays activated after 30 seconds,
return to the closest boat landing,
and contact your closest authorized
Honda Marine dealer.
COOLING SYSTEM iNDICATOR
When the overheat indicator system is
activated:
1. Return the gearshift lever or control
lever to the N (neutral) position
immediately. Check to see if water
is flowing out of the cooling system
indicator.
2. If water is flowing out of the cooling
system indicator, continue idling for 30
seconds. If the overheat indicator
system stops after 30 seconds, the
system is normal.
If the engine is turned off after
running at full throttle, the engine
temperature may rise above normal.
If the engine is restated, shortly
after being turned off, the overheat
indicator system could be activated
momentarily.
3. If the overheat indicator system
stays activated, stop the engine, tilt
up the motor and check the water
intakes for obstructions. If there are
no obstructions at the water intakes,
return to the closest boat landing,
and contact your closest authorized
Honda Marine dealer.
76