Life Fitness 9500 Series Service Manual page 47

Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To... REMOVE AND REPLACE THE REAR ROLLER / ROLLER BELT
Tools Required: Hex key wrench set, socket and ratchet set, torque wrench
Step 1
Turn the power OFF at the ON/OFF switch and by unplugging the machine at the electrical outlet.
Step 2
Use a hex key wrench to remove the three SCREWS from each of the REAR FRAME CAPS.
Step 3
Remove the STRIDING BELT (See "How To..."). Leave the machine leaning on its left side.
Step 4
Remove the two SCREWS from the UPPER BRACKET of the ANTI-STATIC CORD to the FRAME and move the
CORD out of the way.
Step 5
Use a socket and ratchet wrench to loosen the four DRIVE MOTOR MOUNTING BOLTS and the ADJUSTMENT
BOLT.
Step 6
Slide the DRIVE MOTOR ASSEMBLY towards the REAR ROLLER and loop the ROLLER BELT off the TRANSFER
PULLEY.
Step 7
Remove the four SCREWS securing the REAR ROLLER GUARD to the FRAME. Remove the GUARD and set it
aside.
Step 8
Use a socket and ratchet wrench to loosen and remove the two MOUNTING BOLTS and four WASHERS securing
the worn REAR ROLLER to the FRAME.
(Continued)
Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
14