Life Fitness 9500 Series Service Manual page 39

Life Fitness Model 9500 Series HR and Telemetry Equipped Treadmills
How To... REMOVE AND REPLACE THE HANDRAILS
Tools Required: Phillips screwdriver, hex key wrench set, socket and ratchet set
Step 1
Turn the power OFF at the ON/OFF switch and by unplugging the machine at the electrical outlet .
Step 2
Remove the DISPLAY CONSOLE (See "How To...").
Step 3
Remove the FOOT COVER from the HANDRAIL you wish to replace (See "How To...").
Step 4
Loosen and remove the three SCREWS securing the HANDLEBAR FLANGE to the HANDRAIL you are replacing.
Step 5
To replace the RIGHT HANDRAIL simply remove the two BOLTS from the base of the worn HANDRAIL and lift it away
from the machine. Proceed to Step 7.
To replace the LEFT HANDRAIL remove the two BOLTS from the base of the worn HANDRAIL and very carefully tilt
the HANDRAIL away from the machine to allow removal of the HANDLEBAR HEART RATE WIRE HARNESS from the
top of the HANDRAIL. Slowly lift the HANDRAIL and unplug the 10 PIN CONNECTORS located between the base of the
HANDRAIL and the Treadmill FRAME. Set the HANDRAIL down away from the machine.
Step 6
If you have removed the LEFT HANDRAIL carefully withdraw the DISPLAY WIRE HARNESS from the worn HANDRAIL
and transfer it to the new HANDRAIL. (See "How To....)
Step 7
Transfer the DISPLAY CONSOLE BRACKET from the HANDRAIL being replaced to the new HANDRAIL by removing the
three SCREWS and WASHERS securing it in place.
Step 8
Remove the two HANDRAIL ENDCAPS from the worn HANDRAIL and transfer them to the new HANDRAIL.
Step 9
Reverse Steps 1 through 5 to return all parts to their proper position.
NOTE: BE CAREFUL NOT TO PINCH ANY WIRES BETWEEN PARTS
DURING ASSEMBLY OF THE TREADMILL.
6