Using Manager Mode; Manager Screen Descriptions - Matrix MX-A5x Owner's Manual

4.1 UsinG MAnAGer MODe

To enter manager mode, hold the Up and DOWn level keys for three
•
seconds until "MAnAGer" appears on the middle LED display.
QUICKSTART
Press the Up and DOWn elevation keys to scroll between program screens.
•
Press select to modify program setting.
•
Press Up or DOWn level keys to change value.
•
Press qUick stArt to save setting.
•
Press qUick stArt again to exit manager mode.
•
(example changing default time from 20:00 - 30:00 minutes).
cHApter 4: p
rogramming
& e m
ngineering ode

4.2 MAnAGer screen DescriptiOns

p0: Maximum progam time -
•
Sets the total run time of any program.
p1: Default workout time -
•
Workout time when qUick stArt is pressed or when no time is
selected during program set up.
p2: Default resistance level -
•
Starting resistance when qUick stArt is pressed or no resistance
level is selected during program set up.
p3: Default user weight -
•
Weight used for program calorie expenditure calculations.
p4: speed Units - Display value in miles or kilometers.
•
p5: Machine type -
•
Console is shared between the A5x and I5xi. A5x default setting is
"sWinG" and I5xi default setting is "rAMp".
p6: console beep on / off - Confirmation beeps can be turned on or off.
•
p7: Accumulated distance - Total distance of all programs.
•
p8: Accumulated time - Total accumulated program time displayed in hours.
•
p9: Display language -
•
Select between English, Spanish, French Italian, Dutch and German.
p10: software version -
•
Current version of software. Refer to this when calling Matrix Technical Service.
p11: incline calibration -
•
Default display is Off. Selecting On will automatically calibrate the
incline motor (s) to factory settings. Use this feature when actual
elevation does not match console display.
p12: incline reset -
•
This is a software feature that resets machine elevation to 0 degrees
after 30 seconds of user inactivity. During incline reset, movement
can be stopped by pressing any console key. Display will scroll "HOlD
select tO resUMe". To resume reset to 0 degrees, hold "select"key
for three seconds.
p13: Default incline level -
•
Starting incline level at each program start except FIT TEST.
Factory setting is 10%. In FIT TEST, elevation is set to 0%.
p14: error code -
•
Console will record up to three errors. Error codes are stored permanently
unless reset by a technician. To reset error codes, hold MAnUAl and
rAnDOM keys for three seconds. Refer to these error codes when
calling Matrix technical service for assistance.
p15: lcB version -
•
Display will show LCB.VER XX YYY.
XX is machine type.
YYY is version number.