Storage; Preparation For Storage - Honda FR650 Owner's Manual

9. STORAGE
PREPARATION FOR STORAGE
When the tiller will not be used for one month or longer, proper storage
preparation will help to prevent rust and corrosion, and will make it easier to
start the engine when the tiller is removed from storage.
1. Clean all surfaces of the tiller, including the area underneath the tine cover.
Wear heavy gloves to protect your hands.
If you use a garden hose to wash the tiller, observe the following precau-
tions:
l
If the tiller has been running, allow the engine to cool for at least half an
hour before spraying water on it. Never spray water on a hot engine.
l
Wash the tiller using low water pressure, and keep water away from
controls, cable ends, and all other places that are difficult to dry if water
enters.
l
After washing, start the engine outdoors, and let it run until it reaches
normal operating temperature to evaporate any water remaining on the
engine.
l
Stop the engine, turn the fuel valve OFF, and allow the engine to cool
before placing the tiller in storage.
2. Coat areas that may rust with a light film of oil. Lubricate all control cable
cores
with a silicone spray lubricant.
54