Computer Input; Input Source Selection (Rgb: Computer 1/Computer 2) - Sanyo PLC-XW300 Owner's Manual

Computer Input

Input Source Selection (RGB: Computer 1/Computer 2)

Direct Operation
Choose either Computer 1(RGB) or Computer 2(RGB) by pressing the COMPUTER 1 or Computer 2 button
on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
Remote Control
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
Use the Point
2
When Computer 1 is selected, press the Point
3
button to access the submenu items. Use the Point
buttons to select the RGB input source and then
press the SELECT button.
Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.44).
COMPUTER 1 button
Computer 1(RGB)
Computer 1(Scart)
COMPUTER 2 button
Computer 2 (RGB)
buttons to select Input and
or the SELECT button.
buttons to select Computer 1.
Input Menu
Computer
1
27