Installing The Hard Disks Extension Box - Fujitsu PRIMERGY TX200 S2 Options Manual

Accessible drives
7.3

Installing the hard disks extension box

Ê Open the server and remove the front cover or rack front cover as described
in the chapter "Preparation" on page
I
The hard disks extension box is supplied without EasyClick rails. Before
installing a new hard disks extension box you must therefore remove the
EasyClick rails from one of the two dummy covers and mount the
EasyClick rails on the hard disks extension box.
Ê Remove the dummy covers from the two upper 5.25-inch bays for accessible
drives:
Ê Press the two metal tongues of the EasyClick rails inward (1) until the
locking mechanism is released.
Ê Remove the dummy cover from the bay.
Ê Remove the EasyClick rails from one of the dummy covers by removing the
four screws on each side.
I
Note that there are two M3 screws and two UNC screws on each side.
V
CAUTION!
Keep the dummy covers for future use. If you remove the hard disks
extension box again and do not replace it with new drives, the dummy
covers must be reinstalled to comply with EMC regulations and to
satisfy cooling requirements and fire protection measures.
U41593-J-Z156-2-76
Installing the hard disks extension box
19ff.
Options Guide 53