Fujitsu PRIMERGY TX200 S2 Options Manual page 74
Server system
Hide thumbs
Also See for PRIMERGY TX200 S2:
- Start manual (9 pages) ,
- System configuration and order-information manual (17 pages) ,
- User manual (317 pages)
Table of Contents
Advertisement
Installing a parallel interface
Figure 60: Fastening the plug connector at the rear of the housing
Ê Feed the plug connector through the notch at the rear of the housing.
Ê Fasten the plug connector to the rear of the housing using the threaded bolts
supplied (see arrows).
Figure 61: Routing the cable
Ê Route the cable as shown in the photo.
Ê Connect the cable's connector to the parallel port connector on the system
board (see arrow).
Ê Reinstall the ventilation duct over the main memory (see
74
Options Guide
Parallel interface for printers
page
30).
U41593-J-Z156-2-76
Advertisement
Table of Contents
