Installing A Controller (Pci Slots 1-4) - Fujitsu PRIMERGY TX200 S2 Options Manual

Installing a controller (PCI slots 1-4)

8.1 Installing a controller (PCI slots 1-4)
Ê Open the server as described in the
2
1
Figure 46: Removing the rear cover
Ê Push the green fastening slider toward the rear (1).
Ê Remove the PCI slot's rear cover (2).
V
CAUTION!
Keep the rear cover of the PCI slot for future use. If you remove the
controller again and do not replace it with a new one, the rear cover
must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
58
chapter "Preparation" on page
Options Guide
Controller in the PCI slots
U41593-J-Z156-2-76
19ff.