Remoteview Service Board S2 Lp - Fujitsu PRIMERGY TX200 S2 Options Manual
Server system
Hide thumbs
Also See for PRIMERGY TX200 S2:
- Start manual (9 pages) ,
- System configuration and order-information manual (17 pages) ,
- User manual (317 pages)
Table of Contents
Advertisement
RemoteView Service Board S2 LP
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
9.2
RemoteView Service Board S2 LP
I
How to install/remove and configure the RSB S2 LP is described in detail
in the "RemoteView Service Board S2/ S2 LP 1.x, Mounting and Setting
Up" manual.
The preferred mounting location for the RSB S2 is PCI slot 5.
The RSB S2 LP is connected to the system board via a power and a data cable.
The RSB S2 LP kit contains an external power supply.
I
The RSB S2 LP can be equipped with a low-profile bracket. In this case
extend the bracket using the adapter (K668-C63) from the system
accessory pack:
Figure 54: Attaching the adapter
68
97ff.
Options Guide
RemoteView components
U41593-J-Z156-2-76
Advertisement
Table of Contents
