Installing A Hard Disks Extension Box; Preparing The Hard Disk Extension Box - Fujitsu PRIMERGY TX300 S4 Options Manual

Installing a hard disks extension box

6.4 Installing a hard disks extension box
In the base units two 5.25-inch bays for accessible drives can be used to install
a hard disks extension box.
Two variants of the hard disks extension box are available:
– Variant 1:
one bay for a LSP or LSD or slimline FDD, one bay for a slimline CD/DVD
drive and two bays for 3.5-inch hard disks
– Variant 2:
eight bays for 2.5-inch hard disks
Ê Open the server and remove the front cover or the rack front cover as
described in the
"Rack model" on page
6.4.1

Preparing the hard disk extension box

I
The hard disks extension box is supplied without EasyClick rails. You
need 4 M3 screws. Before installing a new hard disks extension box you
must therefore remove the EasyClick rails from one dummy cover and
mount two EasyClick rails on the hard disks extension box.
Ê Remove the dummy covers from the two 5.25-inch bays for accessible drives
(see the section "Equipping of the bays" on page
Ê Press inward on the two metal tongues of the EasyClick rails until the
locking mechanism disengages.
Ê Remove the dummy cover from the bay.
Ê Remove the EasyClick rails from the two dummy covers by removing the four
screws on each side.
I
Note that there are two M3 screws and two UNC screws on each side.
V
CAUTION!
Keep the dummy covers for future use. If you remove the hard disks
extension box again and do not replace it with a new one, the dummy
covers must be reinstalled to comply with EMC regulations and to satisfy
cooling requirements and fire protection measures.
56
section "Floorstand model" on page 21
24.
Options Guide
Accessible drives
or in the section
39):
TX300 S4