Function Key; Setup Mode - Fujitsu M4099D Operator's Manual

Function key

This function allocates setup functions to
up to three setup functions.
NOTE
• You cannot use this function when the setup mode is brought by pressing
status.
• You cannot allocate the following functions: Interface, TP_IF Baud Rate, RS232C Baud Rate,
SCSI ID, Product ID, Setup Mode Lock, Black Background, and Function Key itself.
Allocatable setup functions and other special functions
Setup functions noted above
START key
EJECT key
(Default: Undefined)
The
,
F1 F2
the allocated setup function just by pressing the button whenever the scanner is in the Ready state.
This function is valid even in the setup mode lock state (refer to the next function). However, the
, , and
F1 F2
The following is an example of operation when you allocate START and EJECT keys to the
and buttons respectively.
F2
1. In <<SETUP MODE>> initial screen, press
.
ENTER
The <<SETUP MODE>> menu screen
(Settings or Paper Length Check) appears.
NOTE
The "Settings" screen does not appear and
the "Paper Length Check" screen first ap-
pears when your scanner is not controlled
through the video or TP interface.
6-46
F1
button can be used as a shortcut key which enables you to access
,or
F3
buttons are invalid in setup, browse, and test modes.
F3
, , and
F2 F3
Remarks
START: starts the operation stopped by EJECT and
sends data to the host computer.
EJECT:stops operation and ejects the paper in the
transport unit.
<<SETUP MODE>>
<<SETUP MODE>>
<<SETUP MODE>>
Paper Length Check
buttons. You can allocate
in the Ready
MENU
F1
Settings